robot welding soot purifier? In our side, has always been a good helper for our lives. For business with a small capital entrepreneurs, entrepreneurial choice of welding smoke purifier project to join robot is very has the choice of business opportunities. So, what are you hesitating about? Hurry up!

When the

welding fume purifier is used for a period of time, the inner part of the purification electric field is full of oil pollution. Purification effect will be decreased. Therefore, in the use of equipment, the robot should be timely welding fume purifier maintenance cleaning.

Cleaning and post filter

1, pre filter the power off after ten minutes, the door will be opened for maintenance, pre filter and post filter out, put in the washing tank for 10-15 minutes, gently clean oil online. Rinse clean with water. After cleaning, the filter screen is dried naturally, and the filter screen is put back into the purifier according to the original position.

2, clean electric field cleaning: ten minutes after power cut, open the door, remove the electric field. Put in the washing tank for 10-15 minutes, or with the watering can to spray the cleaning agent to the electric field (electrodes) for 10-15 minutes, with a clean sheet on the electrode or blade plates, with electrode plate from moving down, only the electrode plate most of the oil pollution can be cleaned, once the cleaning is not clean, can repeated cleaning.

3, installation of pipeline cleaning: cleaning staff to remove the pipe cut and bottom section, namely the airborne method, this method is mainly used for cleaning 50 cm square above the vertical flue. The upper end of the flue is fixed with a safety rope, the safety belt is fastened, and the cleaning personnel are installed to clean the oil pollution in the vertical flue from top to bottom.

robot welding fume purifier selection, less cost, but large profit margins. In fact, the selection of a good project is very important. So, robot welding smoke purifier to join, are you ready?